The Sabre is a 50W channel-switching amplifier featuring two EL34 tubes in the output stage.  There are two completely separate channels, each featuring Gain, Bass, Middle, Treble, and Master controls, with a common Presence control, as well as two separate effects loops allowing individual effects to be used for each channel.  The separate EQ controls and effects loops allow individual tailoring of each channel for best no-compromise tone.  The clean channel is capable of tones reminiscent of the finest old Fenders, while the gain channel takes you into modern modded high-gain territory.  The gain channel also features a footswitchable gain boost to take the amp from crunch to over-the-top sustaining distortion - almost like having a three-channel amplifier.  Standard color combinations are black, purple, red, emerald green, fawn, and white with gold or white piping, with many other custom colors available.  

Features include:

• All-tube signal path.  Preamp tubes are ECC83/12AX7.  Output tubes are EL34.   The rectifier uses massive 3-amp 1000V ultra-fast recovery diodes (Ultra-FREDs), for utmost reliability and a tight low end, without the RF noise interference "spikes" inherent in standard rectifiers.
  

• Front panel controls/connections: Input jack,  Channel 1 Gain, Treble, Middle, Bass, Master, Channel 2 Gain,  Treble, Middle, Bass, Master, and Presence (affects both channels).   There is also a bright switch for  channel 1, a channel select switch, a gain boost switch for channel 2 (footswitchable),  and a red and green LED to indicate which channel is active.   A jeweled pilot lamp completes the look.

• Rear panel controls/connections: AC mains input, international voltage selector switch allowing operation at 100V/120V/200V/220V/230V/240V 50/60Hz,  impedance selector switch for 4, 8, or 16 ohm operation, two 1/4" speaker jacks,  and a footswitch jack to control the channel-switching and channel 2 gain boost functions.  Also includes a locking mil-style RV6L bias pot and three tip jacks for easy bias setting without having to remove the chassis from the cabinet.   There are also two separate  line-level (+4dBu) effects loops (one for each channel) using a single 1/4" TRS jack for each (tip is send, ring is return, and sleeve is ground).

• Solid, finger-jointed, void-free birch ply cabinets.  The head is 25 1/2" wide, 10 1/4" tall, and 9" deep.  

• Hefty 16-gauge steel chassis, zinc-plated, yellow chromate conversion coated for durability, corrosion-resistance, and appearance.   Front and rear faceplates are gold anodized aluminum for a durable, classic look.

• All hand-wired "military style" turret board construction,  using chassis-mounted tube sockets, for ease of maintenance and reliability.  Built to last.  Finally - a high-gain channel-switching head that is not wired on a flimsy PC board!

• Premium, tight-tolerance parts are used for lowest noise operation, including  2W carbon film and metal film resistors where appropriate for best tone and lowest noise,  5W metal oxide power resistors, 630V axial-leaded polypropylene film/foil capacitors,  and low-noise, sealed, 2W mil-style RV4 pots.

• Output power:  50W RMS at clipping.
  

• All custom colors are available at no extra charge.  Red tolex sounds best.